Precautions for installation of door and window cover
1. When installing the plywood protective panel, no matter it is a door leaf, door cover or window cover, you should pay attention to the front of the plywood facing outward, not the back facing outward, so as to draw a joke with a rabbit.
2. For the corners of the door cover and window cover, whether it is a protective panel or a decorative wood line, a 45-degree oblique straight line must be drawn with a square, and the slope should be sawed or cut straight according to the line, and then the test should be carried out. After installation, confirm that the corners are straight and tight, and then formally fix them to ensure that the 45-degree angle is neat and tight.
3. After drying the cut surface of the door frame and the two sides of the door leaf with thin wood, if there are defects such as rough edges, use fine wood sandpaper or fine emery cloth to lightly polish along the edge direction, and do not use chisels or planes to repair. In order not to damage other parts.
4. When the surface of the door leaf is required to be inlaid with a lattice pattern, it should be carried out before the door leaf is installed. When inlaying, first lay the door leaf flat, then draw the shape of the lattice pattern with a pencil according to the design pattern, and then inlay it with this kind of wooden lines. Then install the door leaf.
5. For each door leaf after decoration, especially the door leaf against the wall in the living room, a door suction device should be installed at a height of 80-100mm at the corner of the wall and heel. In order to prevent the corrugated corner of the door leaf from bumping into the wall when the door is opened violently, breaking the scratched white wall or damaging the door edge.
6. For the decoration and construction of the door cover of the kitchen, if the door frame is connected in parallel with the window frame of the same wall (mostly wooden windows), the door cover and window cover should be decorated according to the height of the door frame and the height of the window frame at the same time, instead of just decorating the door Otherwise, it will affect the decorative effect of the interior decoration.
7. After pasting the thin wood on the cut surface of the door frame and the two sides of the door leaf, if there are bean-shaped bulges on the surface of the thin wood, you can use a needle or a small back nail to pierce the bubbling 2-3 needle holes, and then press the flat with your index finger. compacted.
8. After installing the wrapping surface of each door leaf, the outer surface of the door leaf should be about 2m high, and the door lock should be installed by drilling or digging.